Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer - Chevrolet Malibu 2007 Malibu Owner's Manual

Turn and Lane-Change Signals

The turn signal has two upward (for right) and two
downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down to the latched position. When the turn is
finished, the lever will return automatically.
To signal a lane change, just raise or lower the
lever until the arrow starts to flash. Hold it
there until you complete your lane change. The
lever will return by itself when you release it.
A warning chime signal will come on if you have left
your turn signal on for more than 2/3 mile (1 km).
172
An arrow on the
instrument panel
cluster will flash in
the direction of the
turn or lane change.
As you signal a turn or a lane change, if the
arrows flash rapidly, a signal bulb may be burned
out and other drivers won't see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when
you signal a turn, check for burned-out bulbs and
then check the fuse. See Fuses on page 447.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to
high beam, push the turn signal/multifunction
lever away from you.
To change the headlamps from high beam to low
beam, pull the turn signal lever toward you.
When the high beams
are on, a light on the
instrument panel cluster
also will be on if the
ignition is in ON.