Related Manuals for Davey Celsior C200A
Summary of Contents for Davey Celsior C200A
- Page 1 Celsior ® Spa Pump Heat Recovery Models: C200A, C270A, C400A, C200AB, C270AB, C400AB, C200TB, C270TB, C400TB Installation and Operating Instructions Please pass these instructions on to the owner of this equipment.
- Page 2 (Pump must be able to self drain) Your Davey Spa Bath Pump Congratulations on your purchase of a quality product from the Davey range of Pool and Spa Equipment. You are assured of many years of reliable and efficient performance from your Davey Spa Bath Pump backed by Davey’s two year guarantee.
-
Page 3: Electrical Connection
(a standard ON/OFF power point provides this). If the supply cord of this product is damaged it must be replaced with a genuine Davey Spare Part, by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard. -
Page 4: Plumbing Installation
Plumbing Installation This product is supplied with barrel unions which accept 40mm PVC pipe. In all cases, the pump must be installed so that the suction line of the pump slopes from the pump to the bath suction cap with a recommended minimum gradient of 1:60 or 1 degree. -
Page 5: Pump Operation
Pump Operation Fill the bath to the correct level. Air Switch Models Depress the air button to operate the pump. Depress the air button again to switch off the pump. Never run the pump dry. Running the pump with no water may damage the mechanical seals, causing leakage and flooding. -
Page 6: Activating Air Bleed
To re-set the heater, press the button on the rear of the pump control box. If the heater continues to cut-out service attention will be required. In the event of installation or operation difficulties with your Davey Spa Bath Pump, contact the supplier from whom the pump was purchased or your nearest Authorised Davey Pool Equipment Service Centre. - Page 7 WARNING: Davey Spa Bath Pumps (heated and non heated models) are capable of pumping water with temperatures up to 50°C. However, medical authorities recommend that the average temperature of spa water should not exceed 40°C. Spa bath pump & pipework hygiene - soap residue and body oil deposits must be regularly flushed from the spa pipe work to ensure that the spa does not foster bacteria growth and promote unhygienic conditions.
- Page 8 To the fullest extent permitted by law Davey disclaims any warranties regarding the accuracy, completeness or reliability of App data. Davey is not responsible for any direct or indirect loss, damage or costs to the User arising from its reliance on internet connectivity.