Pioneer DEH-X1810UB/XNUC Service Manual page 13

5
Common
AMP ERROR
This unit fails to operate or the speaker
connection is incorrect.
The protective circuit is activated.
– Check the speaker connection.
– Turn the ignition switch OFF and back
to ON again. If the message remains,
contact your dealer or an authorized
Pioneer Service Station for assistance.
NO XXXX (NO TITLE, for example)
There is no embedded text information.
– Switch the display or play another
track/file.
CD player
ERROR-07, 11, 12, 17, 30
The disc is dirty.
– Clean the disc.
The disc is scratched.
– Replace the disc.
ERROR-07, 10, 11, 12, 15, 17, 30, A0
There is an electrical or mechanical
error.
– Turn the ignition switch OFF and back
to ON, or switch to a different source,
then back to the CD player.
ERROR-15
The inserted disc is blank.
– Replace the disc.
ERROR-23
Unsupported CD format.
– Replace the disc.
FORMAT READ
Sometimes there is a delay between the
start of playback and when you start to
hear any sound.
– Wait until the message disappears and
you hear sound.
NO AUDIO
The inserted disc does not contain any
playable files.
– Replace the disc.
SKIPPED
The inserted disc contains DRM
protected files.
– The protected files are skipped.
PROTECT
All the files on the inserted disc are
embedded with DRM.
– Replace the disc.
5
6
DEH-X1810UB/XNUC
6
7
USB device
FORMAT READ
Sometimes there is a delay between the
start of playback and when you start to
hear any sound.
– Wait until the message disappears and
you hear sound.
NO AUDIO
There are no songs.
– Transfer the audio files to the USB
device and connect.
The connected USB device has security
enabled.
– Follow the USB device instructions to
disable the security.
SKIPPED
The connected USB device contains
DRM protected files.
– The protected files are skipped.
PROTECT
All the files on the connected USB
device are embedded with DRM.
– Replace the USB device.
N/A USB
The connected USB device is not
supported by this unit.
– Disconnect your device and replace it
with a compatible USB device.
HUB ERROR
The USB device connected via a USB
hub is not supported by this unit.
– Connect the USB device directly to this
unit using a USB cable.
CHECK USB
The USB connector or USB cable has
short-circuited.
– Check that the USB connector or USB
cable is not caught in something or
damaged.
The connected USB device consumes
more than maximum allowable current.
– Disconnect the USB device and do not
use it. Turn the ignition switch OFF
and back to ACC or ON. Connect only
compliant USB devices.
7
8
A
B
C
D
E
F
13
8