Samsung Chef NV51M9770 Series Installation Manual page 14

Installation instructions
3-Wire Cable from Home Power Supply - U.S. Only
IMPORTANT: Use the 3-wire cable from home power supply where local codes
permit a 3-wire connection.
A
B
C
D
E
F
Cable from home power
A.
supply
B. Junction box
C. Black wires (normally L1)
D. White wires (normally
N-neutral)
E. green wires (normally
G-ground)
F. 4-wire flexible conduit from
oven
G. Red wires (normally L2)
H. UL listed wire connectors
I. UL listed or CSA approved
conduit connector
14 English
Install_NW9000K_CHEF_WALL-DG68-01005A-00_EN+MES+CFR.indb 14
Connect the 2 black wires (C) together
1.
using a UL listed wire connector.
2. Connect the 2 white wires (D) and
G
the green (or bare) ground wire (of
H
the oven cable) using a UL listed wire
connector.
3. Connect the 2 red wires (G) together
using a UL listed wire connector.
I
4. Install junction box cover.
Install oven
1.
Carefully push against front oven frame.
Install
Handle
2.
3.
4.
Using 2 or more people, lift the oven
partially into the cabinet cutout. Hang
the install handle onto the side hook of
the oven as shown below.
NOTE
Push against the seal area of the front
frame to push the oven into the cabinet
until the back surface of the front frame
touches the front wall of the cabinet.
Push oven completely into the cabinet
and center the oven into the cabinet
cutout.
Remove the tape from front trims.
• Securely fasten the oven to the
cabinet using the screws provided.
Insert the screws through hole in
•
trim aligning with hole in oven
frame. Do not overtighten screws.
7/31/2017 4:43:21 PM