Faults And What To Do About Them - Siemens WM16Y8891W Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Faults and what to do about them.

en
Display
Drum care information:
Other displays
Error E:XXX
Faults and what to do about them.
Faults
Water is leaking from the
appliance.
The appliance is not filling
with water.
The dispenser is empty
and the fill level indicator
is not flashing.
The wrong detergent/
fabric softener has been
poured into the
dispenser(s).
Detergent/fabric softener
has congealed in the
dispensers.
The door cannot be
opened.
The programme will not
start.
The drum briefly jerks or
judders after the
programme has started.
46
Cause/remedy
This instruction reminds you to carry out the Drum Clean 90 °C programme or
a 60 °C programme to clean and care for the drum and the outer tub.
Notes
Run the programme without laundry.
Use washing powder or a detergent containing bleach. To prevent
foaming, only use half the amount of detergent recommended by the
detergent manufacturer. Do not use detergents designed for woollens or
delicates.
Switch reminder information on/off. ~ Page 13
Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call the after-sales service.
Cause/remedy
Attach the drain hose correctly or replace it.
Tighten the threaded joint on the inlet hose.
Have you pressed the Ü button?
Is the tap turned on?
Could the filter be clogged? Clean the filter.
Is the inlet hose kinked or trapped?
Is the drawer cover/connector dirty? Cleaning ~ Page 36
Has the detergent drawer been pushed in correctly? Insert correctly.
~ Page 41
Dispenser(s):
Empty and clean.
1.
2.
Refill. ~ Page 35
Clean and refill the dispensers.
The safety function is activated. Cancel the programme? ~ Page 32
Is the w childproof lock activated? Deactivate. ~ Page 32
Is $ selected (Rinse Hold = no final spin)? ~ Page 33
Can the door only be opened by the emergency release? ~ Page 44
Have you pressed the Ü or Finish in button?
Is the door closed?
Is the w childproof lock activated? Deactivate. ~ Page 32
Not a fault – the internal motor test may cause the drum to jerk or judder
briefly when the wash programme starts.

Advertisement

Table of Contents
loading

Table of Contents