Table of Contents
Advertisement
Before using for the first time
Setting the rinse-aid dosage
You can adjust the rinse-aid dosage for
best results.
The rinse-aid dosage can be set from 0
to 6 ml.
3 ml is the factory default setting.
The rinse-aid dosage can turn out to be
higher than the set value due to the au-
tomatic adjustment of the program.
If spots appear on dishes and glass-
ware:
- Increase the rinse-aid dosage.
If clouding or smearing appears on
dishes and glassware:
- Decrease the rinse-aid dosage.
22
Turn the dishwasher off with the
button, if it is turned on.
Press the Start button in and, while
holding it in, turn the dishwasher on
using the button.
Keep the Start button pressed in for
at least 4 seconds until the Start indi-
cator light comes on.
If this does not happen, start the proce-
dure from the beginning again.
Press the Program button 3 times.
The left program indicator light will flash
rapidly 3 times at intervals.
The set value will appear in the display
after .
will start flashing in the time display.
Setting 3 is set.
Use the Start button to select the re-
quired setting.
The dosage amount increases each
time you press the button. When the
highest value is reached, the setting
starts again from the beginning.
The setting is now saved.
Turn the dishwasher off with the
button.
Advertisement
Table of Contents
