Table of Contents
Advertisement
3. MENU settings
USER SW <continued>
The following table shows all functions that can be assigned to the USER buttons.
Menu item
EVF/LCD DETAIL
IR REC
(AG-UX180 only)
LOW LIGHT
(AG-UX90 only)
LEVEL GAUGE
BACK GROUND
(AG-UX180 only)
FLASH BAND
PRE-REC
WFM
(AG-UX180 only)
FAST ZOOM
EVF ON/OFF
(AG-UX180 only)
A.IRIS LEVEL
ZEBRA
O.I.S
SCENE FILE
AUTO REC
AF AREA
VFR
FOCUS MACRO
i. ZOOM
USB MODE
AWB
Make focusing easier by enhancing the subject's edge on the viewfinder
and built-in LCD monitor.
The level of this enhancement and the frequency can be set using the
"EVF/LCD PEAK LEVEL" and "EVF/LCD PEAK FREQ." items of the
DISP menu.
Turn ON/OFF the Infrared shooting mode.
Set camera sensitivity mode. LOW LIGHT mode is suitable for shooting
in dark environments.
Display a level gauge on the viewfinder for the horizontal and vertical
axis'. Inclinations can be indicated up to approx. 45 degrees in the
horizontal, and up to approx. 10 degrees in the vertical directions.
Start or pause the recording in slot No.2 when the "Background record
function" is enabled.
Turn ON/OFF the image compensation function, which allows removing
flash-bands from the image.
Turn ON/OFF the pre-record mode. This mode allows the camera to start
recording video and audio approx. 4 sec (in MOV/MP4 mode, 3 sec in the
AVCHD mode) before the REC/PAUSE button is pressed.
Display the Waveform or Vector scope on the built-in LCD monitor.
Open the "WFM TYPE" item of the SW SETUP menu to select the item
(Waveform or Vector scope).
Increase servo zoom speed.
Note: When this feature is turned ON, motor's operation sound becomes
louder, and may be audible and recorded.
Turn ON/OFF the EVF display.
Turn ON/OFF the level adjustment mode for auto iris.
Turn ON/OFF the ZEBRA indicator.
Turn ON/OFF the optical image stabilizer.
Save or load scene file data between an SD memory card and the
camera.
Turn ON/OFF sending the embedded REC-Start/-Stop signal to external
recorders connected via SDI OUT.
Adjust the size of window where auto focus (AF) is enabled via jog dial.
Turn ON/OFF variable frame rate mode.
Turn ON/OFF the macro mode. With macro mode ON, focus adjustable
range at Wide-end is from 10cm to infinity. (With macro mode OFF, from
1meter to infinity.)
Turn ON/OFF the "i.Zoom" mode which allows the camera to magnify the
image (electronically) up to x30 (x25 for AG-UX90) at the Tele-end. This
mode can only be enabled when resolution setting is 1920x1080 or lower.
Enable/disable the USB connection mode.
Perform auto white balance adjustment.
Description
21
Advertisement
Table of Contents
