olympia electronics GR-1938/15L Manual

WATERPROOF SELF TESTING MAINTAINED EMERGENCY LUMINAIRES WITH WHITE LEDs
TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY (Ni-Cd)
BATTERY PROTECTION
INDICATIONS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
ILLUMINATION SOURCE
ILLUMINATION (MAINS / EMERGENCY)
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
GENERAL
These luminaires are used in places where
emergency luminaires are needed.
E a c h l u m i n a i r e m u s t b e p e r m a n e n t l y
connected to mains power supply.
In normal operation (L1 connected to L) the
led strip lights and the battery is charging.
In case of a mains power supply failure
t h e l u m i n a i r e w i l l n l i g h t t h e l e d s t r i p
automatically in emergency mode (powered by
its battery). When the mains power supply
is restored the device turns to normal
operation.
INSTALLATION
To install the luminaire follow the installation
instructions on page 3.
Battery Charging
The battery charging is completely controlled.
Thereby, the
maintenance is achieved, as well as the
elongation of its duration. When the battery
has completely charged, it charges with a
maintenance current.
Battery Cut-off
The luminaire enters in this operation when
the mains power supply fails and battery has
Page 1 from 4
GR-1938/15L
3.4W / 3.8VA
3.6V/0.6Ah
15 white LEDs
105lm / 105lm
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
595gr.
Thank you for your trust in our products
Olympia Electronics - European manufacturer
best possible
(for LED MODULE Specs see page 4)
GR-1938/30L
220-240V AC/50-60Hz
4.5W / 4.9VA
3.6V/1.5Ah
From overcharge and deep discharge
Charge, Lamp Fault, Battery Fault LED
90min
30 white LEDs
210lm / 210lm
5 to 40 C
Up to 95%
Bayblend FR3010, transparent polycarbonate
313 x 118 x 66 mm
3 years (1 year for the battery)
lost its energy. During this operation the
luminaire enters the idle state and battery
consumption is negligible, in order to be
protected from deep discharge.
Manual Test
This test can be done by placing the test card
on the side of the indications (page 4) and
remove it instantly an operation test is
initiated. The light source and the emergency
circuit of the device is monitored. The manual
test can be conducted only if the main power
supply and the battery is connected. During
this test period all indication LEDs are OFF.
Automatic operational test
This test includes all the operations that
provide the manual test and is conducted
automatically every 15 days. In order to be
performed, the mains power supply and the
battery
battery should be connected.
Automatic Autonomous Test
The Automatic Autonomous Test is conducted
and measures the device's back up operation
and emergency
conducted automatically every 6 months. In
order to be performed, the mains power
GR-1939/15L
3.3W / 3.7VA
24h
180min
15 white LEDs
105lm / 105lm
IP 65
o
675gr.
duration.
923193901_09_008
GR-1939/30L
5.3W / 5.6VA
3.6V/3Ah
30 white LEDs
210lm / 210lm
745gr.
This test is