Kelkay 45023L Chimenea Falls Easy Instructions

Easy fountain Instructions
45023L Chimenea Falls
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.
STAGE 1
Position the water feature onto a secure and level surface.
STAGE 2
Referring to the diagram above, position the 'fireplace' part into the opening at the back of the water
feature. Push the cable with 2 pins into the transformer and screw over the plastic collar.
STAGE 3
Position the pump in the reservoir through the opening in the lower back of the feature and connect
the LED light to the cable which extends from the pump. Connect the tubing to the pump outlet.
STAGE 4
Thread the long transformer wire through the opening in the lower back of the feature. Push the
cable with 2 pins into the transformer and screw over the plastic collar.
STAGE 5
Carefully fill the fountain with sufficient water taking care to fully submerge the pump.
STAGE 6
Connect both the plugs to your mains outlet.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
PUMP FLOW: The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
www.kelkay.com
ELECTRICAL SAFETY: If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.