Kelkay easyfountain Tuscan Vase 45022L Instructions

Easy Fountain Instructions
45022L Tuscan Vase
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.
STAGE 1
Position the water feature onto a secure and level surface.
STAGE 2
Following the diagram above, position the pump inside the reservoir in the base of the feature and
connect the LED light wire to the cable which extends from the pump.
STAGE 3
Locate the internal water pipe from inside the feature and attach the end to the pump outlet.
STAGE 4
Thread the long transformer wire through the opening in the back of the fountain. Push the cable
with 2 pins into the transformer and screw over the plastic collar.
STAGE 5
Carefully fill the fountain with sufficient water ensuring the pump is fully submerged.
STAGE 6
Connect the plug to your mains outlet.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
PUMP FLOW: The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
www.kelkay.com
ELECTRICAL SAFETY: If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.