Kelkay Sicillian Jugs Instructions

Easy Fountain Instructions
45021L - Sicillian Jugs
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.
STAGE 1
Position the water feature onto a secure and level surface.
STAGE 2
Carefully position the top most urn into place at the top of the water feature ensuring that the
internal water pipe is fed down into the fountain and that the spout is facing toward the middle urn.
STAGE 3
Through the opening at the back of the fountain, locate the internal water pipe and attach the end of
it onto the pump outlet. Attach the LED wires to the cable which extends from the pump.
STAGE 4
Thread the long transformer wire which extends from the pump through the opening in the back of
the fountain. Push the cable with 2 pins into the transformer and screw over the plastic collar.
STAGE 5
Carefully fill the fountain with sufficient water ensuring that the pump is fully submerged.
STAGE 6
Connect the plug to your mains outlet.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
PUMP FLOW: The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
www.kelkay.com
ELECTRICAL SAFETY: If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.