Advertisement
Using Your Kambrook Desk Fan
Before First Use
Remove any promotional material
from fan.
WARNING: When
unpacking the fan,
check to see you have
received all the items
listed in the Parts List,
before discarding the
packaging.
Assembling Your Kambrook
Desk Fan
NOTE: Assembly of the desk
fan requires a Phillips head
screwdriver.
1.
Using a screw driver, unscrew the
large screw and washer at the
bottom of the fan pole stand and
fit the pole stand into the aperture
located at the centre of the flat
base. Turn the pole stand over
and screw both together with
the washer situated between the
screw and the base (See Fig. 1).
8
Washer
Fig. 1
2.
Remove the black PVC protective
sleeve from the motor head shaft.
Unscrew the 4 small screws and
washers situated on the motor
head (See Fig. 2).
3.
Separate the blades, front
and rear grilles by opening the
securing clips all around the front
grille and untying the securing
wire away from the fan blades.
4.
Thread the motor head through
the centre hole of the rear
grille, placing the rear grille into
position. Make sure that the
carry handle on the back of
the rear grille is located above
the motor head.
Ensure the rear grille mounting
holes are aligned with the
mounting holes on the motor
head and fix the grille into position
with the 4 small screws and
washers provided (See Fig.3).
Make sure that the rear grille has
not slipped off the mounting holes
before tightening the screws.
Fig. 2
Advertisement
