Specifications; Packing List - EGO Power+ ST1302E Operator's Manual

◾
Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in operating
condition. Be aware of possible hazards even when
the tool is not operating. Take care when performing
maintenance or service.
◾
Do not wash with a hose; avoid getting water in motor
and electrical connections.
◾
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If
you loan this tool to someone else, also loan these
instructions to them to prevent misuse of the product
and possible injury.
◾
Always wear substantial footwear and long trousers
while operating the machine.
◾
Always be sure of the footing on slopes and to walk,
never run.
SAVE THESE INSTRUCTIONS!

SPECIFICATIONS

Voltage
No-load Speed
Cutting Mechanism
Cutting Line Type
Cutting Width
Weight (without battery pack)

PACKING LIST

PART NAME
Line Trimmer
Guard
Front-assist Handle Assembly
Hex Wrench
Screws for Locking Shaft
Operator's Manual
DESCRIPTION
KNOW YOUR LINE TRIMMER (Fig. A)
1. Trigger
2. Rear Handle
3. Lock-off Lever
8
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1300E-S
4. Speed Adjustment Switch
5. Soft Sleeve
6. Adjustable Front-assist Handle
7. Trimmer Head (Bump Head)
8. Bump Knob
9. Line-cutting Blade
10. Guard
11. Ejection Mechanism
12. Electric Contacts
13. Latch
14. Battery-release Button
ASSEMBLY
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
56 V
create accessories not recommended for use with this line
5200-6500 /min
trimmer. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
Bump Head
serious personal injury.
AL0802 2.0mm
Nylon twist line
cause serious personal injury, always remove the battery
33 cm
pack from the tool when assembling parts.
2.76 kg
UNFOLDING THE SHAFT
order to avoid pinching your hands or fingers.
QUANTITY
until the shaft has been locked. Unfold the shaft gently,
1
ensuring the cable inside the shaft, and lock it with two
screws by the supplied wrench (Fig. B & C).
1
MOUNTING THE GUARD
1
1
replacing the guard. Take care of the blade on the guard
2
and protect your hand from cutting.
1
guard firmly in place. The guard must always be on the
tool to protect the user! When the guard was fixed,
never attempted to remove or adjust the guard, if
replace needed, it shall be performed by a qualified
service technician!
WARNING:
If any parts are damaged or missing,
WARNING:
Do not attempt to modify this product or
WARNING:
To prevent accidental starting that could
WARNING:
Do not hold the shaft at the joints in
WARNING:
Do not attempt to start the trimmer
WARNING:
Always wear gloves when mounting or
WARNING:
Never operate the tool without the