Camera Mounting - Novus NVIP-4V-6511/F User Manual

NVIP-4V-6511/F - User's manual (short form) ver 1.0
START-UP AND INITIAL CAMERA CONFIGURATION

2.3. Camera mounting

To mount a camera please follow the instructions below:

Unscrew the screws from upper camera cover.

Remove the camera cover.

Put the bracket to the wall in a desired mounting place (with cable hole). Take the drill pattern
and mark future drilling holes for screws and wires.

Drill holes in accordance with previously done markings and base hole placement.

If necessary mount microSD card in the socket.

Connect the camera wires.

Mount the camera base using the supplied plugs and screws.

Adjust camera position.

Put on the camera cover and screw the screws.
CAUTION!
Please note that the wall or ceiling must have enough strength to carry the IP Camera.
CAUTION!
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop-through ones, seal them too.
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
10