Heatilator GDST4336IFT Installation Manual page 57

Step 3. Crease fl aps on left and right sides of splatter
guard using the scored line as the guide. See Figure 11.4
Figure 11.4 Folding of Right and Left Sides of Splatter Guard
Step 4. Center the splatter guard in front of the unit as
shown in Figure 11.5. Place the splatter guard in the unit
by guiding the top fl ap into proper position and then con-
tinuing to guide the tabs on the side fl aps into the top slot
on the left and right sides of the appliance. The top slot is
indicated in Figure 11.6. Take care not to bend or break
off the tabs.
Figure 11.5 Installation of Splatter Guard
Figure 11.6 Top slot
Heatilator • GDST4336IFT, GDFL4136IFT Installation Manual • 2480-980 Rev. B • 3/17
TOP SLOT
Step 5. Fold bottom fl ap along score line as indicated in
Figure 11.7 and tuck into valve access area of appliance.
Splatter guard should fi t securely on front of unit.
Figure 11.7 Folding Bottom Flap
Figure 11.8 Prepare to Open Lower Access Panel
Step 6. To open lower access panel of splatter guard, place
one hand above score line and place two fi ngers from other
hand in the round holes on the front of the splatter guard.
See Figure 11.8. Pull out and fold up the panel as shown
in Figure 11.9. Disengage the tabs on left and right bottom
of splatter guard and fi t them into the square holes. The
tabs are now inside the front of the splatter guard; carefully
bend them down. See Figure 11.10.
Figure 11.9 Opening Lower Access Panel
57