Table of Contents
Advertisement
ADJUSTING SPEAKER OUTPUT LEVELS
3
Adjust the level of the
effect speakers using +/–
so that it matches the
level of the main
speakers.
While adjusting, the test tone
is heard from the selected
speaker.
Note
• To adjust the level of the main speakers, use VOLUME knob
(or VOLUME h/g on the remote control).
4
When adjustment is
complete, press TEST to
stop the test tone.
Notes
• If "1A CENTER" on the SET MENU is set to NON and the
center speaker is not connected, the center channel sound is
automatically output from the main left and right speakers.
• If "1C REAR LR" on the SET MENU is set to NON, the
output level of the rear left and right speakers cannot be
adjusted in step 3. The test tone will be circulated skipping the
rear right and left speakers.
• If "1D BASS" on the SET MENU is set to MAIN, the test tone
will be circulated skipping the subwoofer.
y
• It is not necessary to readjust the speaker levels once they are
set (as long as you do not change the speakers). You can enjoy
listening to or watching the input source at the desired volume
simply by adjusting the VOLUME knob (or VOLUME h/g on
the remote control).
• If the output level of the effect speakers (center, rear left, and
rear right) cannot be increased enough to match the level of the
main speakers, set "1E MAIN Lv" on SET MENU to –10 dB
(see page 42). This setting decreases the main speaker output
level to about one-third of the normal level. After you have set
"1E MAIN Lv" on the SET MENU to –10 dB, adjust the levels
for the center and rear speakers again.
22
–
+
DSP
TEST
Advertisement
Table of Contents
