Chevrolet 2010 Equinox Owner's Manual page 112

This display can be used as a timer.
To start the timer, press
CLR while Timer is displayed. The
display will show the amount of time
that has passed since the timer was
last reset, not including time the
ignition is off. Time will continue to
be counted as long as the ignition is
on, even if another display is being
shown on the DIC. The timer will
record up to 99 hours, 59 minutes
and 59 seconds (99:59:59) after
which the display will return to zero.
To stop the timer, press
CLR briefly while Timer is displayed.
To reset the timer to zero, press and
hold or SET/CLR.
The speedometer shows how fast
the vehicle is moving in either
kilometers per hour (km/h) or miles
per hour (mph). The speedometer
cannot be reset.
This display is used for the OnStar
or Navigation System Turn-by-Turn
or SET/
guidance. See
manual, if the vehicle has
navigation, for more information.
This display shows no information.
Press the MENU button until Vehicle
Information Menu is displayed. Then
or SET/
press to scroll through the
following menu items:
Unit
Tire Pressure
Remaining Oil Life
Blank
or the Navigation
Press or SET/CLR to enter the
unit menu. Then press
switch between US or Metric when
the Unit display is active. Press
or SET/CLR to confirm the setting.
This will change the displays on the
cluster and DIC to either metric or
English (US) measurements.
The display will show a vehicle with
the approximate pressures of all
four tires. Tire pressure is displayed
in either pounds per square
inch (psi) or in kilopascal (kPa).
Any time the tire pressures are
adjusted the system needs to
relearn the new pressures. To
relearn the tire pressures press
SET/CLR while the Tire Pressure
display is active. The display will
ask for confirmation of a relearn.
Press or to select Yes or No.
Then press or SET/CLR to
confirm the selection. See
or to
or