Getting Started; Battery Removal And Installation - VTech MARVEL SPIDEY LEARNING WATCH Instruction Manual

WARNING
People with very sensitive skin may notice some irritation after wearing
the Spidey Learning Watch for extended periods of time. The skin
may become irritated when moisture, sweat, soap, or other irritants
get trapped under the wristband and are left in contact with the skin.
To prevent this, we suggest children remove the watch before going
to bed for the night, take the watch off if it's feeling uncomfortable, and
keep their wrist and the band clean and dry.
In addition, wearing the watch too tightly may also cause irritation. Make
sure the fit is enough so the watch stays in place but not so tight that it's
uncomfortable. If you notice any redness, swelling, or other irritation,
you may want to consult a doctor before wearing the watch again.

GETTING STARTED

Battery Removal and Installation

1. Close the cover of the watch.
2. Find the battery cover located on the back
of the unit, use a screwdriver to loosen the
screw and then open the battery cover.
3. Remove the old battery by pulling up on one
end of the battery.
4. Install one new CR2450 battery as illustrated.
5. Replace the battery cover and tighten the
screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
4 4
4