Advertisement
12
Operation
Preparation
Turn on the unit the transmitter is
connected to.
Turn the volume on the sound source
up as much as possible without
causing distortion.
Sound is more susceptible to noise interference
when the source volume is set to low.
Remove the headphones from the
transmitter.
Reduce the volume of the headphones
with the [VOL] dial.
Switch the [OPR] switch to "ON"
The OPR indicator goes red.
Put the headphones on.
Press the [TUNING] button to adjust
the frequency.
The frequency is adjusted automatically.
Adjust
the
headphones.
If there is interference, you can change the
transmitter channel to improve reception (
page 14).
To use the SURROUND sound feature,
set the [SURROUND] switch to "ON".
The surround sound effects will differ depending on
the audio.
After listening
Take the headphones off.
Switch the [OPR] switch to "OFF".
The OPR indicator goes out.
Reset the headphones on the transmitter, and
recharge them.
Turn off the unit the transmitter is connected to.
Note
● Avoid listening for prolonged periods of time to prevent
hearing damage.
● Discontinue use if you experience discomfort with the
headphones that directly contact your skin.
Continued use may cause rashes or other allergic
reactions.
Concerning the AUTO POWER ON/OFF
function:
When audio signals are input, the transmitter's power is
turned on (The OPR/CHG indicator lights in green.). When
audio signals are not input for 1-2 minutes, its power is
automatically turned off. (The OPR/CHG indicator goes out)
When the volume of the connected unit is too low, this
function doesn't work. Turn up the volume as much as
possible without causing distortion.
volume
on
the
see
Advertisement
Chapters
