Advertisement
10
Operation
Turn on the unit the transmitter is
connected to.
Turn the volume on the sound source
up as much as possible without
causing distortion.
Sound is more susceptible to noise interference
when the source volume is set to low.
Remove the headphones from the
transmitter.
Reduce the volume of the headphones
with the [VOL] dial.
Switch the [OPR] switch to "ON"
The OPR indicator goes red.
Put the headphones on.
Adjust
the
headphones.
If there is interference, press the
[TUNING] button to reduce it.
The frequency is adjusted automatically.
See page 12 for more detailed instructions on how
to reduce interference.
After listening
Take the headphones off.
Switch the [OPR] switch to "OFF"
The OPR indicator goes out.
Reset the headphones on the transmitter, and
recharge them.
Turn off the unit the transmitter is connected to.
Note
● Avoid listening for prolonged periods of time to prevent
hearing damage.
● Discontinue use if you experience discomfort with the
headphones that directly contact your skin.
Continued use may cause rashes or other allergic
reactions.
Concerning
the
AUTO
function:
When audio signals are supplied, the transmitter's power
is turned on (The OPR/CHG indicator lights in red.); when
audio signals have not been supplied for 2 or 3 minutes,
its power is automatically turned off. (The OPR/CHG
indicator goes out.)
When the volume of the connected unit is too low, this
function doesn't work. Turn up the volume as much as
possible without causing distortion.
volume
on
the
POWER
ON/OFF
Advertisement
Chapters
