Table of Contents
Advertisement
REVERSING THE DOOR (cont.)
B REVERSING THE DOOR - GLASS
PANEL DOOR MODELS (cont.)
6
Remove and swap the 2 plastic caps and the 2
hinges.
Plastic
caps
Hinges
7
Rotate the outer door 180 degrees, mount the
inner door back into the outer door frame and
secure with the screws removed in step 5. Make
sure you mount the hinges on the side opposite
the pocket.
Inside
screws
Pocket screws
Inner door
Inside
screw
Inside
screw
Installation Instructions
Install plastic caps
from oposite side
here
Install hinges from
oposite side
here
Inner door
Inside screw
Inside
screw
Outer door
Rotate outer
door 180°
B REVERSING THE DOOR - GLASS
PANEL DOOR MODELS (cont.)
8
Mount the assembled door on the 2 upper left side
hinge screws installed in step 2. Move the hinge
screws loosened in step 2 into the lower left side
screw holes and firmly tighten all 4 screws.
Door
9
Install the 4 plastic caps removed in step 1 into the
4 right side front panel holes.
Door
hinge
screws
Right side of
front panel
NOTE: To return the door to the original setup, follow
these instructions, swapping "left" and "right".
When you finish
Plug the dryer back into
its electrical outlet.
20
Plastic Cap (4)
Hang door and
tighten screws
Advertisement
Table of Contents
