Table of Contents
Advertisement
Door opening
NOTE
The refrigerator doors are designed to
shut by themselves within a 45 degree
opening.
Your refrigerator should be positioned
to allow easy access to a counter when
removing food. For best use of refrigerator
drawers and freezer baskets, the
refrigerator should be in a position where
both can be fully opened.
CAUTION
Do Not loosen or remove these 3 hex
screws.
Cabinet Leveling &
Refrigerator Door Align-
ment (if necessary)
Guidelines for final positioning of your
refrigerator:
•
All four corners of the cabinet must
rest firmly on the floor.
•
The front should be slightly elevated
to ensure that doors close and seal
properly.
•
Doors should align with each other
and be level.
Most of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the cabinet using the front rollers:
1 Slightly open freezer drawer if the toe
grill is installed. Lift the toe grille and
gently pull forward.
2 Make initial cabinet adjustments by
using the front roller height adjusting
screws. Use a 3/8 inch socket
wrench to turn the adjustment
screws (1 per side).
To raise: turn adjustment screw
clockwise.
To lower: turn adjustment screw
counterclockwise.
Anti-tip
Leg
DO NOT
Loosen
or
Remove
These 3
3 Ensure both doors are bind-free with
Hex
their seals touching the cabinet on all
Screws
four sides and that cabinet is stable.
4 After unit is leveled, lower anti-tip leg
using a 3/8 inch socket wrench until
it firmly contacts the floor.
5 Install the toe grille by fitting into place.
Installation
Raise
Lower
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(3) Retaining Clips
7
Advertisement
Table of Contents
