Table of Contents
Advertisement
Operating the appliance
en
activate it again as necessary once the
programme has started.
Adding laundry
After starting the programme, you can
add or remove laundry as required.
To do this, press the Start/Pause
button.
The Start/Pause indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
Do not leave the washing
Note:
machine door open for too long when
adding laundry as water from the
laundry may leak out.
If the display panel shows:
Both the YES and ¼ symbols lit up,
■
it is possible to add laundry.
A flashing NO symbol, wait until YES
■
and ¼ light up.
Do not open the door until both the
YES and the ¼ symbols are lit.
A flashing NO symbol, it is not
■
possible to add laundry.
For safety reasons, the washing
machine door remains locked when
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry.
To continue the programme, press
the Start/Pause button. The
programme continues automatically.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Press Start/Reload.
1.
Select the other programme.
2.
Press Start/Reload . The new
3.
programme starts from the
beginning.
20
Cancel the programme
Programmes at high temperatures:
Press Start/Reload.
1.
To cool the laundry: Select Rinse.
2.
Press Start/Reload .
3.
For programmes at low temperatures:
Press Start/Reload.
1.
Select Spin or Drain.
2.
Press Start/Reload.
3.
Programme end during rinse
hold
– – – 0 appears on the display panel
and the Start/Reload button indicator
lamp flashes.
To end the programme, set the
programme selector to Spin/Drain or
select a spin speed. Then press the
Start/Reload button.
Programme end
End appears on the display panel and
the Start/Pause button indicator lamp is
off.
If the 9 symbol appears on the display
panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.
Removing laundry/switching
off the appliance
Open the washing machine door
1.
and remove the laundry.
Set the programme selector to Off.
2.
The appliance is switched off.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Advertisement
Table of Contents
