Table of Contents
Advertisement
10
www.electrolux.com
If after some tries the burner
does not light, check if the
crown and its cap are in the
correct position.
In the absence of electricity
you can ignite the burner
without an electrical device.
In this case approach the
burner with a flame, push the
relevant knob down and turn
it to maximum position. Keep
the knob pushed for equal or
less than 10 seconds to let
the thermocouple warm up.
If the burner accidentally
goes out, turn the knob to the
off position and try to light the
burner again after minimum 1
minute.
The spark generator can start
automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
5.2 Burner overview
I
H
G
I
H
G
A) Burner cap
B) Burner crown
C) Ignition candle
D) Thermocouple
E) Hob
F) Slots
G) Burner body
H) Location peg
I)
Hole
5.3 Replacing burner parts
1. Put carefully the burner crown on the
burner body. Let the crown fall freely
onto the body. Do not use force.
Make sure that the hole in the crown
is above the ignition candle.
A
Make sure that the location pegs are
in the slots in the burner body.
Make sure that you can move the
B
crown a small distance from side to
side.
2. Put the burner cap centrally on top of
C
the crown (enamel side up).
D
Make sure that the cap is correctly
installed and you can move the cap
E
from side to side and front to back.
F
3. Try to light the burner.
If the burner does not ignite, adjust the
crown and cap again.
5.4 Turning the burner off
To put the flame out, turn the knob to the
off position
.
A
B
C
D
E
F
Advertisement
Table of Contents
