Finding A Station; Setting Preset Stations - Chevrolet 2008 Cobalt Owner's Manual

Finding a Station

BAND: Press this button to switch between FM1 and
FM2, AM, or XM™ (if equipped). The selection displays.
f
(Tune): Turn to select radio stations.
© ¨
SEEK : Press the arrows to go to the previous or
to the next station and stay there.
To scan stations, press and hold either arrow for a few
seconds until a beep sounds. The radio goes to a
station, plays for a few seconds, then goes on to the
next station. Press either arrow again to stop scanning.
The radio only seeks and scans stations with a
strong signal that are in the selected band.
4
(Information) (Radio with CD (Base)): Press to
switch the display between the radio station frequency
and the time. While the ignition is off, press this button to
display the time.
4
(Information) (XM™ Satellite Radio Service, MP3,
and RDS Features): Press to display additional
text information related to the current FM-RDS or
XM™ station, or MP3 song. A choice of additional
3-60
information such as: Channel, Song, Artist, and CAT
(category) can display. Continue pressing to highlight the
desired label, or press the pushbutton positioned
under any one of the labels and the information about
that label displays.
While information is not available, No Info displays.

Setting Preset Stations

(Radio with CD (Base Only))
Up to 18 stations (six FM1, six FM2, and six AM), can
be programmed on the six numbered pushbuttons,
by performing the following steps:
1. Turn the radio on.
2. Press BAND to select FM1, FM2, or AM.
3. Tune in the desired station.
4. Press and hold one of the six numbered
pushbuttons for three seconds until a beep sounds.
When that pushbutton is pressed and released,
the station that was set, returns.
5. Repeat Steps 2 through 4 for each pushbutton.