ORDER NO. MD0702008CE Speaker System SB-HS750P Colour (K)... Black Type Specification Type 1 way, 1 speaker system (Bass reflex) Mass 0.6 kg (1.32 lbs) Impedance 3 Ω Speaker unit(s) Full range 6.5 cm (2-1/2”) cone type Notes : Input power (IEC) 125 W* (Max) 1.
The diagrams below show the breakdown for speaker combinations used in main unit systems. SB-PT750P-K consists of SB-HF750P-K (x2), SB-HS750P-K (x2), SB-HC750P-K (x1) & SB-HW750P-K (x1) 1.2. Packaging Information Note : Please refer to service manual of SB-HF750P-K (MD0702006CE) to understand the packaging condition for SB-HS750P-K.
SB-HS750P 2 Assembling and Disassembling “ATTENTION SERVICER” Some chassis components may have sharp edges. Be careful when disassembling and servicing. 1. This section describes procedures for checking the operation of the major printed circuit boards and replacing the main components.
SB-HS750P 2.2. Disassembly of Rear cabinet assembly Step 4: Apply light force to push out the front panel as arrow shown. Caution: Do not exert strong force as it may damage the rear cabinet assembly. Step 1: Remove 4 screws.
SB-HS750P 3 Connection of the Speaker Cables · Be sure to connect speaker cables before connecting the AC power supply cord. · The load impedance of any speaker used with this unit must be 3 Ω. · Be sure to connect the cable from the right speaker to the right terminal and the cable from the left speaker to the left terminal.
Page 8
SB-HS750P Note on speaker use · Use only supplied speakers. Using other speakers can damage the unit, and sound quality will be negatively affected. · You can damage your speakers and shorten their useful life if you play sound at high levels over extended periods.
SB-HS750P 6 Replacement Parts List Notes : · Important safety notice : When replacing any of these components, be sure to use only manufacturer’s specified parts shown in the parts list. · [M] markings in the Remarks columns indicates parts supplied by PAVCSG.