Troubleshooting - Swann activair SAC16870N Manual

Problem
The unit doesn't operate
The device runs for a
short time but stops auto-
matically
The device works but
doesn't produce cold air
LED display shows error
code: E1
LED display shows error
code: E2
SAC16870N_IM.indd 15
TROUBLE SHOOTING
Possible cause
Check power cord and
fuse
The device has entered
security mode
If using remote control,
check that batteries are
not discharged
Water tank is full
Check air outlet is not
obstructed
Timer has been activated
Room has reached target
temperature
Check target tempera-
ture is not higher than
room temperature
Check if a door or window
is not open
Check if another heat
generating device is not
working (radiator or lamp
for example)
Check air filter is dirty
Check if outlet or air inlet
are not obstructed
Room temperature sen-
sor is not working
The temperature sensor
on the evaporator is not
working.
15
Solution
Replace fuse if necessary.
Connect power cord.
Wait 3 minutes before
pressing the On/Off but-
ton.
Replace batteries
Drain the tank
Remove obstacle
Reset the timer
Lower target tempera-
ture if required.
Lower target tempera-
ture
Close doors and windows
Turn off these devices
Clean air filter
Remove obstacles
Call service. Number on
front page of this manual
Call service. Number on
front page of this manual
27/03/2020 11:11