First Use - TECHWOOD TCL-9002 Instruction Manual

• remove the appliance and all accessories carefully.
• Clean the outside of the appliance with a damp sponge or cloth and wipe it.
• Install the appliance on a table or flat, stable and horizontal surface. Make sure
there is enough space to operate the machine properly.
• Unwind the power cord completely.
• Check that the voltage in the country where you are, corresponds to that
indicated on the device.
• Connect the appliance to a good electrical outlet, (earthed if the appliance is
class I), to avoid any danger.
• Disconnect the power cable from the power supply before performing
maintenance, cleaning, and accessory mounting.
• Never modify the device.
Cooling mode
When the air conditioner goes into cooling mode, after turning on the power, the
cooling indicator lights up.
Press the "Up / Down" keys to set the desired temperature. (from 16 to 30 ° C).
Press the "Speed" button to choose the speed. (Sweet or Strong)
Fan mode
By pressing the Mode key (2), it is possible to select the "Ventilation" mode. Press
either the remote control or the control panel. the ventilation indicator lights up.
Press the "Speed" button to choose the speed. (Sweet or Strong)
Note: In this mode, temperature cannot be set.
Dehumidifier mode
By pressing the Mode key (2) it is possible to select the mode "Dehumidify". Press
either on the remote control or on the control panel. the dehumidification indicator
lights up.
Remove the drain cork and insert one end of the hose to collect the drain water.
The other end of the hose should be introduced into a suitable container such as a
bottle or small jerry can.
In dehumidification mode, when the temperature reaches ≥17 ° C (62 ° F), the
compressor starts. When the ambient temperature drops below ≤15 ° C (59 °
F), the compressor stops. When the temperature rises to an ambient temperature
above 17 ° C, the compressor protection system will restart it 3 minutes later).
Notes : In dehumidification mode :

FIRST USE

USE
22