Lexus UX 250h 2023 Owner's Manual, Quick Manual page 73

4
Test the HomeLink
ing the indicator light:
● Indicator light illuminates: Programming of a fixed code device has completed. The
garage door or other device should operate when a HomeLink
and released.
● Indicator light flashes rapidly: The garage door opener motor or other device is
equipped with a rolling code. To complete programming, firmly press and hold the
®
HomeLink
● If the garage door or other device does not operate, proceed to "Programming a
rolling code system".
5
Repeat the steps above to program another device for any of the remaining
®
HomeLink buttons.
Programming a rolling code system
■
2 or more people may be necessary to complete rolling code programming.
®
operation by pressing the newly programmed button and observ-
button for 2 seconds then release it.
1
Locate the "Learn" or "Smart" button
on the garage door opener motor in
the garage.
This button can usually be found where
the hanging antenna wire is attached to
the unit. The name and color of the but-
ton may vary by manufacturer. Refer to
the owner's manual supplied with the
garage door opener motor for details.
2
Press and release the "Learn" or
"Smart" button.
3
Perform within 30 seconds after
2
performing .
3
Press and
®
HomeLink button (inside the vehicle)
for 2 seconds and release it. Repeat
this sequence (press/hold/release) up
to 3 times to complete programming.
If the garage door opener motor oper-
ates when the HomeLink
pressed, the garage door opener
motor recognizes the HomeLink
nal.
®
button is pressed
hold the desired
®
button is
®
sig-
72