Cleaning; Cleaning The Dryer And The Control Panel; Cleaning The Heat Exchanger - Siemens WT46G400IN Installation And Operating Instructions Manual

Table of Contents

Advertisement

Cleaning

en
D
Cleaning
C leaning the dryer and the
C l e a n i n g
control panel
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Disconnect the dryer from the mains
before cleaning.
Clean the dryer using only water and a
soft, damp cloth.
Remove all detergent residue, spray
residue or other residues immediately.
Do not use cleaning agents or agents
for pre-treating laundry (e.g. prewash
sprays, stain removers). Do not use
high-pressure cleaners or steam jet
cleaners to clean your appliance.

Cleaning the heat exchanger

Notes
Clean the heat exchanger several
times a month if you use the dryer
more than twice a week.
If there is debris in the heat
exchanger, this will increase the
amount of time required for drying
and will compromise the drying
results.
Allow the dryer to cool down and
1.
place an absorbent cloth beneath
the maintenance flap.
Residual water may leak out.
Note:
Open the maintenance flap fully.
2.
28
Turn both locking levers towards
3.
each other.
Remove the top cap from the heat
4.
exchanger.
Remove the heat exchanger.
5.
Flush water through the heat
6.
exchanger from all sides to
completely remove all fluff.
Caution!
There is a risk of damage to the heat
exchanger.
Only use water to clean the heat
exchanger, and do not use any hard
objects or objects with sharp edges
to remove the fluff.
Remove all fluff from the seals on
7.
the dryer and on the heat exchanger.

Advertisement

Table of Contents
loading

Table of Contents