Kenmore DU3002 Use & Care Manual page 10

PILE HEIGHT SELECTION AND SETTINGS
Select a pile height setting by turning the
height adjust selector located on the nozzle.
SUGGESTED PILE HEIGHT SETTINGS
Attention: Refer to your carpet
manufacturers cleaning recommendations.
Some more delicate carpets may require
that they be vacuumed with the agitator
turned off to prevent carpet damage.
There are four (4) pile height settings on the
vacuum cleaner. For best deep down
cleaning, use the LO setting. However, you
may need to raise the height to make some
jobs easier, such as scatter rugs and some
deep pile carpets, and to prevent the
vacuum cleaner from shutting off.
Suggested settings are:
HI – Shag, deep pile, or scatter rugs.
MED HI – Medium to deep pile.
MED LO – Low to medium pile.
LO – Most carpets; Bare floors (combined
with Floor / Tools selector in Bare Floor
position); Delicate carpets that require
agitator to be turned off.
CAUTION
Do not allow vacuum cleaner to remain
in one spot for any length of time when
the agitator is turning. Damage to carpet
may occur.
ABOVE FLOOR MODE
1. When using in Above Floor Mode, verify
that the FLOOR/ TOOLS Selector is in the
TOOLS position.
2. Press WAND
RELEASE button.
3. Pull up to
release wand for
above floor
cleaning.
4. Slide attachment into the open end of
wand. Use attachments as needed. See
ATTACHMENT USE TABLE (page 12).
- 10 -