Table of Contents
Advertisement
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
symbol.
B
Setting the brightness
Press and hold the
B
symbol until the required
brightness is reached.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols flash once the
appliance has been switched off:
Metal grease filter:
E
■
Activated charcoal filter:
■
Metal grease filter and activated charcoal filter:
■
and
F
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 7
The saturation displays can be reset while they are
flashing. To do this, touch the
Switching over the display for the air circulation
mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Touch and hold the
:
■
selector to change the display to 2. Take your finger
off the
symbol. This switches the electronic
:
controller over to air recirculation mode (filters that
cannot be regenerated).
Touch and hold the
:
■
selector to change the display to 3. Take your finger
off the
symbol. This switches the electronic
:
controller over to air recirculation mode (filters that
can be regenerated).
Repeatedly touching and holding the
■
changing the display to "1" switches the electronic
controller back to air extraction mode.
Audible signal
Switching on
Touch and hold the
and
#
time for approximately three seconds when the fan is
switched off. As confirmation, an audible signal sounds
and
is shown in the display.
‚
Switching off
Touch and hold the
and
#
time for approximately three seconds when the fan is
switched off. As confirmation,
F
E
or
F
symbol.
symbol. Use the rotary
symbol. Use the rotary
symbol and
:
symbols at the same
y
symbols at the same
y
is shown in the display.
‹
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
2Cleaning and maintenance
:
Warning
C l e a n i n g a n d m a i n t e n a n c e
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Warning
Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning
Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
E
:
Warning
Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
:
Warning
Risk of injury!
Risk of trapping body parts when opening and closing
the glass front. Do not reach into the area behind the
glass panel, and keep your fingers away from the
hinges.
Cleaning agents
To ensure that the different surfaces are not damaged
by using the wrong cleaning product, follow the
instructions in the table. Do not use any of the following:
Harsh or abrasive cleaning agents, e.g. scouring
■
powder or liquid scouring cleaner,
Cleaning products with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
Pressure washers or steam cleaners,
■
Cleaning products that dissolve limescale,
■
Aggressive all-purpose cleaning products,
■
Oven spray.
■
Wash new sponge cloths thoroughly before use.
Note:
Follow all instructions and warnings included with
Note:
the cleaning products.
Cleaning and maintenance en
7
Advertisement
Table of Contents
