Table of Contents
Advertisement
Fan run-on time
Switching on
Touch the
symbol.
x
The fan will run at fan setting 1.
After approximately 10 minutes, the fan will switch itself
off automatically.
Switching off
Touch the
symbol.
x
This immediately stops fan run-on.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols will flash once
the appliance has been switched off:
Metal grease filter:
!
■
Activated charcoal filter:
■
Metal grease filter and activated charcoal filter:
■
and
"
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 9
The saturation indicators can be reset while they are
flashing. To do this, touch the
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Touch and hold the
#
■
time until "2" lights up for air recirculation mode
(filters that cannot be regenerated).
Repeatedly touching and holding this button
■
combination makes "3" light up for air recirculation
mode (filters that can be regenerated).
Repeatedly pressing and holding this button
■
combination switches the electronic controller back
over to air extraction mode ("1" ).
Audible signal
Switching on
Touch and hold the
#
and
for approximately 3 seconds when the fan is switched
off. An audible signal will sound as an
acknowledgement.
When the signal tone is activated,
Switching off
Touch and hold the
and
#
for approximately 3 seconds when the fan is switched
off. An audible signal will sound as an
acknowledgement.
When the signal tone is deactivated,
"
symbol.
A
and
@
symbols at the same
&
symbols at the same time
will be lit.
‚
symbols at the same time
&
‹
will be lit.
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
!
Operating the appliance en
7
Advertisement
Table of Contents
