Siemens LC64PBC50 Instructions For Installation And Use Manual page 15

Hide thumbs Also See for LC64PBC50:
Table of Contents

Advertisement

Installation
en
Exhaust duct
The device manufacturer does not assume any
Note:
warranty for complaints attributable to the pipe section.
The device achieves its optimum performance by
means of a short, straight exhaust air pipe and as
large a pipe diameter as possible.
As a result of long rough exhaust air pipes, many
pipe bends or pipe diameters that are smaller than
150 mm, the optimum extraction performance is not
achieved and fan noise is increased.
The pipes or hoses for laying the exhaust air line
must consist of non-combustible material.
Round pipes
An inner diameter of 150 mm, but at least 120 mm, is
recommended.
Flat ducts
The inner cross-section must correspond to the
diameter of the round pipes.
dia. 150 mm ca. 177 cm
dia. 120 mm ca. 113 cm
Flat ducts should not have any sharp deflections.
Use sealing strips for deviating pipe diameters.
Connecting the appliance to the power
supply
Connecting the air extractor
If using an aluminium pipe, smooth the
Note:
connection area beforehand.
Attach the air extractor pipe directly to the air-pipe
1.
connector.
Connect to air extractor opening.
2.
Seal the joints appropriately.
3.
Connect the power supply
Plug the mains plug into the earthed socket.
1.
If a fixed connection is required, please follow the
2.
instructions in the Electrical Connection section.
14
2
2
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Attaching the flue duct
:
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Separate the flue ducts.
1.
To do this, remove the adhesive tape
Remove the protective foil from both flue ducts.
2.
Screw the upper flue ducts to the sides of the fixing
3.
bracket using two short screws.
Place the lower flue ducts on the appliance and fix in
4.
place using two long screws on the bottom of the
appliance.
©
Screw the lower flue duct to the sides of the fixing
5.
bracket using 2 short screws.
Align the flue duct before tightening the 2
Note:
screws.
¨
ª

Advertisement

Table of Contents
loading

Table of Contents