Step 15 Dishwasher Wet Test; Step 16 Replace Toekick - Frigidaire FFBD1821MW Installation Instructions Manual

STEP 15 DISHWASHER WET TEST

¨ Turn on power supply (or plug power cord into outlet,
if equipped).
¨ Turn dial to Normal "Wash" position.
¨ Close door.
¨ Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, check to be
sure that water and power are turned on.
¨ Check for leaks under the dishwasher. If a leak is
found, turn power supply off, then tighten
connections. Restore power after leak is corrected.
¨ Check for leaks around the door. A leak around the
door could be caused by door rubbing or hitting
against adjacent cabinetry. Reposition the
dishwasher if necessary. See Step 9.
¨ The dishwasher will drain and turn off about 5 to 7
minutes after the first fill. Check drain lines. If leaks
are found, turn power off at the breaker and correct
plumbing as necessary. Restore power after
corrections are made. See Step 12.
¨ Open dishwasher door and make sure most of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
See Step 13. Also check drain line for kinking.
¨ Run the dishwasher through another fill and drain
cycle. Check for leaks and correct if required.
¨ At the end of drain, open door and turn dial to OFF
position.
Installation Instructions

STEP 16 REPLACE TOEKICK

Use Top 4
Screw Holes
2 - P i e c e T o e
Adjust Up
or Down
Figure Y
• Place 2-piece toekick against the legs of the
dishwasher.
• Place the inner toekick piece (with slots) against the
toekick bracket. The slots should align with toekick
bracket screw holes. Allow the toekick to touch the
floor.
• Place larger toekick over the inner piece and install 4
toekick screws.
• Use additional 2 screws that are provided for
installations over 33-1/2" high.
• Use both toekick pieces for all installation heights.
STEP 17 LITERATURE
Be sure to leave complete literature package and
installation instructions with consumer.
k i c k