Advertisement
3
INSTALL THE LENS. (See figure-3)
Remove protective caps(front and
1.
back) on the lens.
Mount the lens on mounting bracket of
2.
the main cabinet with 4 screws.
Use the screws included with the lens.
Use the driver included with the lens
to fasten the screws.
(After using, save it for latter use.)
4
INSTALL THE LIGHT-BLOCK SHEET. (See figure-4)
Install the light-block sheet around the lens as shown in Figure.
When this projector permanently install in the
structure, slide the picture, obtain correct
focus, then lock the lens by Focus Lens Lock
screw at this step.
In case unfixing the focus lens, remove the
screw.
5
MOUNT THE LENS COVER. (See figure-5)
When in install the both upper and lower lens
covers, install the light-block sheet so that it
should be placed in the guide slot of the lens
cover. If the installation of the light-block
sheet is incorrect, there will be the space
between lens and the lens cover, so that it will
be the cause of leakage of light or the dust
entering at the main cabinet.
1.
Insert the upper part lens cover and
fix them with screws A (4 screws).
2.
Insert the lower part lens cover and
fix them with screws B. (2 screws).
ATTACHED DRIVER
Set the light-block sheet, so
that the large rounder side is
set over the lens.
LENS MOUNTING BRACKET
LIGHT-BLOCK SHEET
UPPER LENS COVER
A
B
LOWER LENS COVER
Fig-3
FOCUS LENS LOCK SCREW
Fig-4
A
Fig-5
Advertisement
