Electric, 2200 psi max pressure at initial discharge per csa internal pressure testing, 1.65 gpm max flow with nozzle open at minimum pressure (21 pages)
+ Sun Joe customer service ® ® WARNING! center at 1-866-SNOWJOE (1-866-766-9563). When using the pressure washer, basic safety precautions should always be followed to reduce the WARNING! Do not use this appliance without reading risk of fire, electric shock, and personal injury. These include: this instruction manual.
® ® modify the plug provided with the unit. If it will not fit the outlet, 1-866-SNOWJOE (1-866-766-9563). have a proper outlet installed by a qualified electrician. Do not use any type of adapter with this unit. • Keep the machine on a stable, flat surface during operation, handling, transportation, and storage.
3. Ground fault circuit interrupter (GFCI) protection – This 6. To prevent the appliance cord from disconnecting from the pressure washer is provided with a ground-fault circuit- extension cord during operation, make a knot with the two interrupter (GFCI) built into the plug of the power-supply cords as shown in Table 1.
Product Description Purpose • This electric high pressure washer is intended for residential use. It is designed for medium-to-heavy duty cleaning jobs on boats, motorcycles, RV’s, ATV’s, trailers, decks, barbecues, siding, patio furniture, and more. Areas of application • Never use the machine in potentially explosive areas under any circumstances! •...
Safety Symbols The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbols Descriptions Symbols Descriptions READ THE OPERATOR'S MANUAL(S) – Read, understand, and follow all instructions in the WARNING! Electrical shock hazard.
Know Your Commercial Grade Pressure Washer Read the owner’s manual and safety rules carefully before operating the pressure washer. Compare the illustration below to the unit in order to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
® ® replace with the oil measuring plug. 1-866-SNOWJOE (1-866-766-9563). 2. Flip up the pump cover to expose the oil inlet nut. Use a NOTE: Do not discard the shipping carton and packaging wrench to loosen and remove the oil inlet nut by twisting it material until you are ready to use your new electric counterclockwise (Fig.
Page 9
NOTE: Be sure to retain the oil inlet nut in event that the WARNING! Keep hose away from sharp objects. pressure washer needs to be transported. Bursting hoses may cause injury. Examine hoses regularly and NOTE: Use the oil inlet nut when transporting the pressure replace if damaged.
Operation Fig. 11 Safety lock Using the Pressure Washer 1. Position the washer as CLOSE as possible to the water Slot supply. 2. The washer must be used on a secure and stable surface in a standing, upright position (Fig. 9). Fig.
Adjusting Pressure Fig. 14 The unit is equipped with adjustable pressure technology. Use the adjustable pressure valve to raise or lower pressure. To increase pressure, twist clockwise; to decrease pressure, twist counter-clockwise (Fig. 13). Slot Fig. 13 Adjustable pressure valve Safety lock Raise the pressure...
Page 12
7. Run clean water through the detergent tube to remove any WARNING! When being used with detergent, the unit remaining detergent. Then, remove and store for later use. MUST NOT be set to a high pressure setting. CAUTION! 1. Remove the cap from the detergent tank and fill the tank Damage may occur to painted surfaces if with detergent (Fig.
Storage III) Use the 25º fan-tip nozzle (green) to clean home siding, brick patios, wood decks, driveways, or sidewalks. When using this nozzle, test a small area first to avoid CAUTION! Always store your commercial pressure surface damage. washer in a location where the temperature will not fall IV) Use the 40º...
Maintenance Fig. 20 Oil measuring plug CAUTION! Before working on the pressure washer, disconnect the plug from the power supply socket. Change Pump Oil The pump was filled with standard 5W-40 synthetic oil at the factory. Check the table below for compatible pump oil and MIN.
® ® Filter 1-866-SNOWJOE (1-866-766-9563). Model + Serial Numbers When contacting the company, reordering parts, or arranging service from an authorized dealer, you will need to provide the model and serial numbers, which can be found on the decal located on the housing of the unit.
• Pump seals worn out. • Please call the Snow Joe + Sun Joe customer ® ® service center at 1-866-SNOWJOE (1-866-766-9563) for assistance. Machine stops • Fuse has blown. • Replace fuse. Switch off other machines using the same circuit.
NOTE: Accessories are subject to change without any obligation on the part of Snow Joe + Sun Joe to provide notice of such ® ® changes. Accessories can be ordered online at sunjoe.com or via phone by contacting the Snow Joe + Sun Joe customer ® ® service center at 1-866-SNOWJOE (1-866-766-9563).
Page 19
To obtain a replacement part or product, please visit Some states do not allow exclusions of incidental or consequential snowjoe.com/help or email us at help@snowjoe.com for damages so the above exclusions may not apply in all states. This instructions. Please be sure to register your unit beforehand warranty may give you specific legal rights in your state.
Need help?
Do you have a question about the Sunjoe SPX9008-PRO-RM and is the answer not in the manual?
Questions and answers