Run time features:
Flow fault features:
Media compatibility:
Housing:
Dimensions:
Weight:
Li-Ion Battery Shipment
Rechargeable, lithium-ion batteries for use with SKC sampling pumps have been
tested in accordance with the UN Manual of Tests and Criteria and are designated as
UN3091.
For air shipments:
Rechargeable lithium-ion batteries in SKC pumps are subject to the A-45 exemption to
the IATA regulations and are not regulated for air shipments. This information must be
written on the shipping document when shipping by air.
For ground shipments:
US DOT regulations specify a limit of 24 or fewer battery cells in one shipping box. If
you exceed 3 QuickTake 30 pumps with battery packs in one shipping box, specific
shipping requirements must be followed. Contact SKC for more information or refer to
the regulatory authority in your area.
See http://www.skcinc.com/instructions/1721.pdf for more information
on maintaining, disposing, and shipping Li-Ion batteries.
Indicates a warning, caution, or note.
User-selectable features, user-adjustable presets (see
Advanced Setup)
Preset timed runs:
Manually set continuous
run with manual shut-off: 1 to 999 min (repeats 1 to 999-min
Intermittent sampling:
If the pump is unable to compensate due to excessive back
pressure, the pump will go into flow fault mode (see page 13 for
details). Flow fault features are enabled as the default setting.
Flow fault may be disabled at the user's option.
See Advanced Setup.
Flow fault:
Flow fault displays immediately.
Pump shuts off after 5 seconds
Fault restart: Pump attempts restart every 10 seconds
up to five times
Viable cascade impactors, spore trap cassettes (e.g., VersaTrap),
asbestos cassettes, wall cavity samplers, and other impaction
samplers that require flows from 10 to 30 L/min
ABS plastic
9.3 x 8.4 x 3.5 in (23.6 x 21.3 x 8.9 cm)
4.8 lbs (2.2 kg)
www.skcinc.com
1, 2, 5, 10, or 15 min
runs indefinitely until user stops
pump or power supply is depleted)
See Advanced Setup
Need help?
Do you have a question about the Quick Take 30 and is the answer not in the manual?