Operation - Honeywell 5101 Operation Manual

http://www.monomachines.com/
IMPORTANT!
Remove plastic corner protectors (A) from
the outside of safe door before operating.
SETUP
STEP 1. OPEN SAFE WITH OVERRIDE KEY
1. Remove override key cover with small
screwdriver.
2. Insert override key and turn left to unlock safe.
3. Turn knob to right and open safe door.
STEP 2. INSTALL BATTERIES
1. Remove battery compartment (A) cover on
inside door. Insert 4 "AA" batteries (included).
Ensure the batteries are installed in the correct
direction, with regard to polarity (+ and -)
See diagram.
2. Replace the battery cover.
3. Do not close door before testing digital lock.
STEP 3. TEST DIGITAL LOCK
1. With door open, turn knob left to put locking door bolts (B) in lock position.
2. Remove override key and store in a secure place.
NEVER STORE KEYS INSIDE SAFE!
3. Enter the preset pass code: "1"-"5"–"9"-"B" .
4. Turn knob to right within 5 seconds.
5. Lock bolts should recede into the unlocked position.
STEP 4. PROGRAM A NEW PASSCODE
1. With door open, press reset button (C)
inside door.
2. Yellow light is on, enter new pass code
in 30 seconds.
3. Enter new code (3 to 8 digits) followed
by "A" or "B".
4. Safe will beep and yellow light will turn off.
NOTE: The factory pre-set code will not work after a new pass code is programmed.

OPERATION

TO OPEN THE SAFE
1. To unlock and open safe, enter the pass code followed by
"A" or "B".
2. Turn door entry knob to the right and open door.
TO CLOSE THE SAFE
Close the door and hold it in the closed position.
1.
2. Turn door entry knob to left to engage the lock bolts and lock safe.
http://www.monomachines.com/
2
SECURE LOCKOUT PERIODS
If a wrong code is entered three times in a row, the digital keypad will begin
a five-minute secure lockout period. During this secure lockout period the
keypad will become disabled. Once the lockout period has expired, the
safe can be unlocked using the correct pass code. You may use the
override key to open safe, but keypad will complete the full lockout period.
OVERRIDE ACCESS KEY
If the pass code is unavailable or your keypad fails due to dead batteries or
other malfunction, you can open the safe using the override access key.
REPLACING BATTERIES
Note: The pass code will not be erased if the batteries become weak or are
removed.
Weak or dead batteries should be replaced immediately and all 4 batteries should
be changed. To replace the batteries please follow the instructions in STEP
2. in the SETUP section.
Remember to always remove batteries from safe if not
using for an extended period of time.
you cannot open the safe by using the digital keypad, use the override
access key to open safe and access the battery compartment.
NOTE: It is NOT RECOMMENDED to use Non-alkaline or rechargeable
batteries.
IF YOU FORGET THE PASSCODE
Use the override access key to open safe.
1.
2. With door open, press red reset button (C)
inside door.
3. Yellow light is on; enter new pass code in 30
seconds.
Enter pass code (3 to 8 digits) followed by
4.
"A" or "B".
5. Safe will beep and yellow light will turn off.
For More Info
Click Here --->
If your batteries are completely dead and
3