Specifications - Haussmann Xpert PNT114-B-175 Manual

ADDITIONAL SAFETY INSTRUCTIONS FOR THE AIR-POWERED HAMMER
Keep the hose away from heat, oil, and sharp edges. Check the hose for wear,

and verify that all connections are secure.
Verify that the air hammer is switched off before connecting it to the air supply.

Disconnect the air hammer from the air supply before changing chisels, and

before performing any type of servicing.
WARNING! Verify that accessories that are used with this tool are rated at or above
the tool's speed rating. Failure to properly match the accessory to the tool could
result in serious personal injury.
Keep air-powered tools clean and lubricated. Daily lubrication is essential in

order to avoid internal corrosion and possible failure.
Using only lightweight coil hoses from the tool to the wall or to the compressor

coupling.
Do not overload the tool. For maximum efficiency, allow the tool to operate at its

optimum speed.
Do not increase the air pressure above the manufacturer's recommended level.

Doing so will cause excessive wear on moving parts, and possible failure.
In the interests of safety and in order to avoid possible damage to the tool and

injury to the operator, verify that the tool has come to a complete stop before
putting it down after use.
Verify that the workpiece is secure in order to free both hands to control the air

hammer.
Verify that accessories, such as discs, are rated/designed for use with this air

hammer. Verify that they are correctly and securely fastened before connecting
the tool to the air supply.
When working, always wear an appropriate face mask and/or respiratory

equipment.
Do not direct air from the air hose at the operator or at others.

When the air hammer is not used, disconnect it from the air supply, and store in

a safe, dry, childproof location.

SPECIFICATIONS

This HAUSSMANN XPERT air-powered hammer provides power for cutting, chipping
and scraping. It is equipped with a durable lightweight aluminum housing. It has a
quick-change spring for fast and easy chisel changes. Its hardened steel barrel and
piston allow for less wear and longer life. It also has a lightweight aluminum pistol grip.
Chisel shank: 3/8" (10 mm)

Bore diameter: 3/4" (19 mm)

No-load speed: 3,500 BPM

Average air consumption: 2.3 CFM (65 L/min)

Operating pressure: 90 PSI

Air inlet size: 1/4" (6 mm) NPT

Air hose: 3/8" (10 mm) I.D.

ACCESSORIES
Chisels

Retainer spring

Tool lubricating oil

1/4" (6 mm) NPT connector

16
PNT114-B-175
4
1
1
1
!