Axis P3925-R Repainting Instructions page 3

AXIS P3925-R Network Camera
Repaint the product
Repaint the product
Preparations
• If applicable, disassemble the device according to the instructions in this document.
• Clean all parts to be repainted thoroughly to remove grease, dust, or oil.
• To ensure reassembly and functionality of the product, mask any openings (for example for screws, LED indicators,
or microphones) before you paint.
Pretreatment of parts
Depending on the part material and type of paint applied at factory, different pretreatment should be done for the new paint to
adhere as well as possible. Clean the parts properly to remove oil, grease and dust.
For more information on the materials used in the product, see its datasheet at axis.com.
Powder coated parts - Use a primer. Alternatively, remove the original powder coating down to the base material, using fine
sandpaper, and clean the parts before painting.
Anodised and chromated parts - Use a primer.
Uncoated stainless steel - No special pretreatment is needed, but make sure that the surface is clean before painting.
Plastic - Use a primer.
Disassembly
2x
TR20
3