Advertisement
System Installation Guide
Link optional accessories to wireless network
4
Portable Comfort Control
CONNECT
WIRELESS SETUP
RedLINK Internet Gateway
TrueSTEAM
Press and release the CONNECT button on the THM4000 Wireless Adapter. After a short delay, the CONNECTED status light will glow
steady green..
Entry/Exit Remote or Vent Boost Remote
Press and release CONNECT button.
69-2688—11 I/O-CHTSTAT03
Press CONNECT on the Portable Comfort Control display screen. Press DONE when the
screen displays "Connected." Press NO at the next screen to save and exit. (Or press
YES to link another thermostat.)
Error messages:
E1 29
E1 34
E1 38
MCR32942
The linking procedure will time out if there is no keypress for 30 minutes. To begin again,
press and hold in the lower right corner of the screen until the display changes (about 3
seconds).
Incompatible device cannot be connected.
Low RF signal. Move device to a different location and try
again.
Make sure the thermostat is in Wireless Setup mode,
and the Portable Comfort Control is at least 2 feet away.
Press and release the button on the bottom of the Internet
Gateway. After a short delay, the RedLINK status light will glow
steady green.
The Internet Gateway must be registered online before
use at www.mytotalconnectcomfort.com. Enter the MAC
ID and MAC CRC numbers located on the bottom of
the Internet Gateway. For additional information, see
MCR32943
instructions provided with the device.
MCR33096
10
After a short delay, the status light will glow
green for 15 seconds. If the status light
turns red, the remote did not link with the
thermostat for the connection process.
Advertisement
