Table of Contents
Advertisement
1
2
Always keep a rag nearby to dry up
any water spillage.
2
1
CAUTION! Never remove the filter
during a washing cycle, always wait
until the appliance has finished the
cycle, and is empty.
Unscrew carefully the
drain filter to drain out the
water.
When no more water
comes out, remove the
filter. If necessary, use
plier hands carefully, do
not use the jaws.
Clean the filter under a
tap, to remove any traces
of fluff.
Remove foreign bodes
and fluff from the filter
seat and from the pump
impeller.
Check carefully whether
the pump impeller rotates
(it rotates jerkily).
Replace the filter into the
pump by inserting it cor-
rectly into the special
guides.
Screw firmly the filter.
Close the pump door.
CAUTION! When refitting the filter,
ensure it is securely re-tightened so as
to stop leaks and young children being
able to remove it.
CLEANING THE INLET HOSE AND THE VALVE
FILTER
1
2
3
EMERGENCY DRAIN
Because of a malfunction, the appliance cannot
drain the water.
If this occurs, do steps (1) through (8) of 'Cleaning
the drain filter'. If necessary, clean the pump.
When you drain the water with the emergency drain
procedure, you must activate the drain system
again:
1. Put 2 litres of water in the main wash
compartment of the detergent dispenser.
2. Start the programme to drain the water.
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can be less than 0° C, remove the
remaining water from the inlet hose and the drain
pump.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
4. Empty the drain pump. Refer to the emergency
drain procedure.
5. When the drain pump is empty, install the inlet
hose again.
45°
20°
17
Advertisement
Table of Contents
