Greenlee 1399 Instruction Manual page 31

Wet Cutting System (cont'd)
Figure 7
7. See Figure 7. Route the coolant hose between the
rear legs and through the coolant tank cover. Attach
the hose to the coolant pump and secure it with a
hose clamp.
8. Add approximately 3 gallons of a water-based
soluble or emulsifying oil type of coolant to the tank
and place the coolant tank in the mounting bracket.
9. Attach the splash guard to the chip pan with two
#10 - 32 x 1/2 round head machine screws (17),
lockwashers (18), and hex nuts (19).
10. See Figure 8. Attach the chip pan and splash guard
assembly to the saw with two 1/4 - 20 x 1/2 thumb
screws (15) and washers (16). Attach one thumb
screw at the tank mounting bracket and the other at
the hole drilled in Step 4A.
11. Attach the warning plate to the head frame with two
drive screws.
12. Connect the coolant pump to the cord set recep-
tacle (installed in Step 3c). Connect the saw to the
power supply.
13. Connect the coolant pump to the band saw switch
(and relay) according to the wiring diagram in the
Maintenance section of this manual.
Greenlee Textron / Subsidiary of Textron Inc.
1399 and 1399-22 Band Saws
SPLASH
GUARD
CHIP
PAN
31 4455 Boeing Dr., Rockford, IL 61109-2988
Figure 8
815/397-7070