Planar PZN2710Q User Manual page 11

Daisy Chain Connection
With USB Type-C/Displayport Multi-Stream Transport (MST) support, you can daisy chain
to another monitor. Connect one end of a DisplayPort/USB Type-C cable to the PZN2710Q
monitor and the other end to a computer. Next connect the Displayport output cable on the
PZN2710Q monitor to the Displayport input of another monitor.
To clone or extend display. In OSD-->Extra-->DP Out-->Extend/Clone.
DP Out DP In DP Out DP In
PZN2710Q PXN2710Q
For a consistent look, Planar recommends the PXN2710Q (998-2123-00).
Note: Make sure your PC supports Displayport MST transport.
USB Connection
Connect one end of a USB cable to a monitor and the other end to your computer.
Note: To utilize the USB Type A ports, ensure your computer is connected to the Type C port.
To comply with International energy standards, the USB hub/ports of this display are
disabled during Standby and Off modes. Connected USB devices will not work in this state.
To permanently put the USB function in "ON" state, please go to OSD Menu, then select "USB
standby mode", and switch it to "ON" state. In OSD-->Extra-->USB Standby Power-->On/Off
Note: Turning off the monitor via power switch will power Off all the USB ports.
10