Table of Contents
Advertisement
7 Installation
7.1 Overview
Installation consists of the following steps:
•
Remove / relocate any old instrumentation
•
Add or locate an appropriate power source / breaker
•
Wire power and interfaces as needed
•
Mount the unit to the instrument panel with supplied screws
•
Apply power and perform setup
Proper mounting orientation is important to ensure performance of the AV-20.
Confirm the unit is oriented level in the roll-axis when installed in the panel.
7.2 Mechanical Drawing
UAV-1003613-001
Rev D
Figure 1 - Mechanical Drawing
10
Advertisement
Table of Contents
