LG LDF5545BD/00 Owner's Manual page 46

46 TROUBLESHOOTING
Problem
Dishwasher chimes if
panel is touched during
operation.
Dishwasher did not finish
cycle.
Leaking in front of unit
P1, P2, P3, or P4 appears
in display.
n:#, U:#, d:#, t#
appearsin display.
(# = a number)
L0, L1, L2, L3 or L4
appears in display.
Possible Cause
Bumping into or touching the control
panel during operation may result in a
disabled button sound. Only the Power,
Start, and Control Lock buttons are
enabled during operation to prevent
cycle settings from being changed
inadvertently.
Door was opened during cycle.
Dishwasher not leveled properly.
Wrong detergent used.
The Download cycle is selected.
Test mode is selected.
Rinse Aid Level setting mode is
selected.
Solutions
• Button sounds can be turned off by
pressing and holding Half Load for three
seconds.
• The end of cycle chime and safety alert
sounds will still sound.
• If the door is opened during a cycle,
the Start key must be pressed within 4
minutes or the machine turns off and all
settings are lost.
• Verify the unit is level from side to side
and from front to back. See leveling
instructions in the Installation section.
• If excessive sudsing is causing the leak,
allow the foam to subside for 24 hours
then clean the inside of the tub with milk.
• This is not an error code. This code
indicates the current Download cycle.
• This is not an error code. This code
is used when testing the dishwasher.
Power the unit off and on and the code
will disappear.
• This is not an error code. This code
indicates the current rinse aid level.
For more information, refer to the Adding
Cleaning Agents section.