LG LDF5545BD/00 Owner's Manual page 32

32 OPERATION
WARNING
• Before adjusting, ensure the rack is empty of all
dishes. Otherwise dishes may get damaged or
you may get injured.
NOTE
• Before pushing the upper rack into the dishwasher,
ensure the rack height is the same on both sides.
If the height is not the same on both sides, the
dishwasher door will not shut and the upper spray
arm will not connect to the water inlet.
• Raise the upper rack without pushing the buttons
on each side. Pushing the buttons when raising the
rack will prevent the rack from locking into position.
• To set the rack to the middle position, it may be
easier to lower the rack all the way down and then
raise each side of the rack individually until it clicks
into place.
• There is a 24 / inches (56 mm) gain in height when
5
8
the upper rack is moved to the lower position.
• After adjusting the rack levels, check that the spray
arms are free to rotate.
• With the lower position of the upper rack, check if
the bottom part of upper rack including spray arm is
not disturbing items on the lower rack.
• When the upper rack is in the lower position, push
in the upper rack first, and the lower rack later.
• Pull out the lower rack first, and the upper rack later.
• Raise the upper rack without pushing the buttons
on each side. Pushing the buttons when raising the
rack will prevent the rack from locking into position.
• To set the rack to the middle position, it may be
easier to lower the rack all the way down and then
raise each side of the rack individually until it clicks
into place.
Removing the Snap-In Gliding Upper
Rack
These instructions are for models with snap-in rack
supports rather than wheeled rack supports.
CAUTION
• The snap-in upper rack should only be removed
for servicing. If you need to remove the rack,
wear gloves and handle the screwdriver carefully
to avoid personal injury or damage to the
dishwasher.
1
Pull the upper rack out until it stops. Remove
any contents from the rack.
2
To remove the front rack supports from the rails,
push the front hooks open with a flat-blade
screwdriver while pulling the front of the rack up
to snap the front rack support out of the hooks.
Repeat to snap the front support out on the
opposite side.
3
To remove the back rack supports from the rails,
hold a side rail with one hand, lift the front of the
rack, and firmly push the rack back to snap the
support out of the hooks in the rear. Repeat on
the opposite side.
4
To replace the rack, place the back rack
supports behind the rear hooks and pull the rack
forward to snap the supports into the hooks.
Then align the front rack supports with the front
hooks and push the front of the rack down to
snap the supports into the front hooks.