Polygroup TZ90M3W48X00 Assembly Instructions

NEED HELP?
DO NOT RETURN TO STORE. PLEASE VISIT US AT:
www.polygroupstore.com
TREE ASSEMBLY INSTRUCTIONS
Congratulations on purchasing your new tree from Polygroup®!
Carefully follow the instructions below on how to quickly and easily set up your new tree.
1. Before you start to assemble your tree, choose an appropriate location near a wall outlet.
2. Assemble the tree stand and place on a level surface. (See Fig. A) Then insert the tree pole tightly into the stand.
3. Sort all branches according to color codes marked on the end of each branch. Below is a list of the color codes for your tree.
(See Fig. B) (Please note: the number of rows may vary with different tree sizes.)
Fig. A - Tree Stand Assembly
SHAPING AND ADDING BRANCHES
1. Shape each branch by either placing the branch in a bracket which is at a comfortable level to work (Fig. 1), or holding the
branch in your hand with the hooked end pointing down. (Fig. 2) BEGIN WITH THE
BRANCHES AT THE BOTTOM OF THE TREE AND WORK UP TOWARDS THE TOP.
2. When shaping each branch, work from the branch hook and move outwards to the end tip of the branch. Start by wrapping the
back tip around the end of the branch stem to cover the branch wire. (Fig. 3)
3. Working from the branch's hook moving outwards, fan each tip out using this pattern: one tip to the right of the branch's center
wire, one tip to the left of the branch's center wire, one tip parallel to the branch's center wire. (Fig. 4) Tips should be slightly
offset from each other so that they do not line up exactly one behind the other. All tips should be curved upwards when looked
at from the side. (Fig. 5)
4. As each branch is shaped, place the color coded branch securely into the matching color coded bracket. (Fig. 6) As you finish
each level of branches, make sure the rows look evenly distributed to the levels above and below it. Adjust tips as needed to
even appearance. (If your tree includes branches with side wings, arrange these branches so that the wings are on every other
branch if necessary.)
5. When all the branches are shaped and put into their color coded matching brackets, shape the top section. Do this by pulling
down each row of tips in an even, circular pattern. (Fig. 7)
1-888-919-0070
OR
Eye Bolt
Fig.B
1.Unfold the legs and lay the stand in
a flat area. Then slide the locking
disc downward and snap into place.
2. When inserting the bottom section
of the tree into the assembled stand,
thread the eyebolt into the stand
and tighten until the pole is firmly
secured.
ROW COLOR CODED
TREE TOP
WITHOUT COLOR
B
RED
C
YELLOW
D
GREY
D
GREY
E
DARK BLUE
F
LIGHT BLUE
G
DARK PURPLE
G
DARK PURPLE
H
GREEN
H
GREEN
I
ORANGE
I
ORANGE
J
WHITE
K
BURGUNDY
L
PINK
1
TREE# : C38
TZ90M3W48X00
MODEL # :
SKU # : 124304249