Table of Contents
Advertisement
E. Auto Channle Scan
1. The Tuner screen will be displayed; default choice is
Antenna. If you are using Cable (No Box) Service,
press
to highlight Cable.
press OK or
2. The Channel Scan screen will be displayed; default
choice is Scan. Press
available channels to be stored into memory.
Note: If you do not want to scan for channels at
this time, press CLEAR to stop scanning.
3. The screen will be change to show the progress if
the search for Analog (NTSC) and Digital (ATSC)
channels.
4. When finished, the Complete screen will be
displayed to inform you that the unit has completed
the Initial Setup.
Press CLEAR to exit and begin watching TV.
Note:
• If you select to skip this step by chosing Skip Scan, or by
pressing CLEAR to stop scanning during Auto Scanning,
next time that you decied to complete this procedure,
you'll need to select the TV as input (through INPUT key)
and then go through the Menu option to select the Signal
Type to get the option of scanning the channels again.
• If you are using a satellite or cable set-top box, you do not
need to complete Channel Search.
After an intial setup is completed:
• You want to scan the channels automatically again, refer
to page 23;
• You can add the desired channels unmemorized by
Channel Skip (P23);
• If you wang to change to another language, refer to page
29;
• If you want to set the time zone, refer to page 25.
to go to the next screen.
to commence the search for
Initial Setup
Please select your tuner mode:
Back
Initial Setup
First, please connect
Start channel scan now?
If you skip this step, the channel
scan could be performed by going to
the Setup menu later.
Back
Initial Setup
Congratulations!
Completed Initial Setup.
Please press [OK] to exit the Initial
Setup Menu.
Back
17
Tuner
Antenna
Cable
Select
Next
Exit
OK
CLEAR
Channel Scan
antenna or
cable.
Scan
Skipscan
Select
Next
Exit
OK
CLEAR
Complete
CLEAR
Exit
Advertisement
Table of Contents
